Figure 65: Areas with missing anatomy shown with and without additional scan feedback – color mode
By default, this mode is enabled, but it can be disabled per case by clicking or by default in the Scan
settings, as described in section 3.6.2.1.
4.2.3.2 Scan color toggle
The color toggle button allows you to toggle between color and monochromatic modes. This applies to
both scanning and viewing all case types.
Figure 66: Model displayed in color and monochrome mode
By default, models are scanned in color, but you can toggle the display per case by clicking or by default
in the Scan settings, as described in section 3.6.2.1.
To Next Page
Loading...
