iTero Element 2 - Editing a Scan; Figure 67: Tap the Opposite Arch or Tap the Arrows to Select It

iTero Element 2 and iTero Element Flex User Manual
© 2019 Align Technology, Inc. All rights reserved.
58
iTero Element 2 and iTero Element Flex User Manual
4.2.3.3 Switching to the next scan segment
During scanning, the current segment is highlighted in blue in the navigation controls, and also displayed in
the segment indicator box, between the arrows.
You can move to the next segment by:
 Tapping on the relevant arch, prep, or bite segment
 Tapping the arrows
Figure 67: Tap the opposite arch or tap the arrows to select it
 Swipe to the left or the right on the wand touchpad.
Note: To enable the wand touchpad, press and release both wand buttons simultaneously.
4.2.4 Editing a scan
After you have scanned the model, you can edit it using the following tools:
 Delete Segment tool, described in section 4.2.4.1
 Delete Selection tool, described in section 4.2.4.2
 Fill tool, described in section 4.2.4.3