Table 66: DHCP Service Configuration Pages Summary for EX4300 Switches (continued)
Your ActionFunctionField
DHCP Pool Information
Type the pool name.Specifies the name of an address-assignment
pool.
Pool Name
Select the option from the list.Specifies the pool name to which it is linked.Link Pool
Network Address
Type an IP address that is part of the subnet
specified in the DHCP Subnet field.
Specifies the IP address pool range.IP Address
Type a subnet mask that is specified in the
DHCP Subnet field.
Specifies the subnet specified in DHCP Subnet.Subnet mask
DHCP Pool Attributes
The pool name is displayed.Displays the name of an address-assignment
pool.
Pool Name
Type the IP address of the server. If you do not
specify a server identifier, the primary address
of the interface on which the DHCP exchange
occurs is used.
Specifies the IP address of the DHCP server
reported to a client.
Server Identifier
Enter the IP address of the TFTP server.Specifies the Trivial File Transfer Protocol
(TFTP) server that the client uses to obtain the
client configuration file.
TFTP Server
Type a number.Specifies the maximum length of time a client
can hold a lease. (Dynamic BOOTP lease
lengths can exceed this maximum time.)
Maximum Lease Time
(Seconds)
Type a path and filename.Specifies the path and filename of the initial
boot file to be used by the client.
Boot File
Type the IP address or hostname of the TFTP
server.
Specifies the TFTP server that provides the
initial boot file to the client.
Boot Server
Type the grace period in seconds.Specifies the grace period for which a client can
hold a lease.
Grace Period
•
To add a DNS server, click Add. Type an IP
address in the Add IP Address pop-up
window.
•
Click OK
•
To remove a DNS server, select the IP
address in the DNS Name Servers box, and
click Remove.
Defines a list of DNS servers the client can use.DNS Name Servers
127Copyright © 2017, Juniper Networks, Inc.
Chapter 10: Configuring Services
To Next Page
Loading...
Need help?
General
