Juniper EX Series User Manual

Table 66: DHCP Service Configuration Pages Summary for EX4300 Switches (continued)
Your ActionFunctionField
•
To add a NetBIOS name server, click Add.
Type an IP address in the Add IP Address
pop-up window.
•
Click OK.
•
To remove a NetBIOS name server, select
the IP address in the WINS Servers box, and
click Remove.
Defines a list of NetBIOS name servers.WINS Servers
Type the name of the domain.Specifies the domain name that clients must
use to resolve hostnames.
Domain Name
Select the type from the list.Specifies the NetBOIS node that provides the
initial node file to the client.
NetBIOS Node Type
•
To add a relay agent, click Add. Type an IP
address in the Add IP Address pop-up
window.
•
Click OK.
•
To remove a relay agent, select the IP
address in the Gateway Routers box, and
click Remove.
Defines a list of relay agents on the subnet, in
the specified order—from top to bottom.
Gateway Routers
•
To add a DHCP option, click Add. The Add
DHCP Option pop-up window is displayed.
Enter the following:
•
Enter the DHCP Code in the Code box.
•
Select the DHCP type from the Type list.
•
Select the DHCP subtype from the Sub Type
list.
•
Enter the DHCP value in the Value box.
•
Click OK.
•
To remove a DHCP option, select the option
in the Option box, and click Remove.
Specifies the DHCP options.Option
Option-82
Type the circuit identifier.Identifies the circuit (interface or VLAN or both)
on the switch on which the request was
received.
Circuit Identifier
Type the range for the circuit identifier.Specifies the circuit identifier range.Ranges
Type the remote identifier.By default, the remote ID is the MAC address of
the switch
Remote Identifier
Type the range for the remote identifier.Specifies the remote identifier range.Ranges
Address Range
Copyright © 2017, Juniper Networks, Inc.128
J-Web Application Package User Guide for EX Series Switches, Release 14.1X53-A1

Juniper EX Series Specifications

General

Brand	Juniper
Model	EX Series
Category	Switch
Language	English