Juniper EX Series User Manual

Table 76: Performance Probe Tests Configuration Fields (continued)
Your ActionFunctionField
Type the IP address in dotted decimal
notation or the URL of the probe target.
If the target is a URL, type a fully formed
URL that includes http://.
Specifies the IP address or the URL of the
probe target.
Target (Address or URL)
Type the source address to be used for
the probe. If you do not supply this value,
the packet uses the outgoing interface's
address as the probe source address.
Specifies the IP address to be used as the
probe source address.
Source Address
Type the routing instance name. The
routing instance applies only to icmp-ping
and icmp-ping-timestamp probe types.
The default routing instance is inet.0.
Specifies the routing instance over which
the probe is sent.
Routing Instance
Type a number from 0 through 255. The
default history size is 50.
Specifies the number of probe results to
be saved in the probe history.
History Size
Request Information
Select a probe type from the list:
•
http-get
•
http-get-metadata
•
icmp-ping
•
icmp-ping-timestamp
•
tcp-ping
•
udp-ping
•
udp-ping-timestamp
Specifies the type of probe to send as
part of the test.
Probe Type
Type a number from 1 through 255 .Sets the wait time (in seconds) between
probe transmissions.
Interval
Type a number from 0 through 86400 .Sets the wait time (in seconds) between
tests.
Test Interval
Type a number from 1 through 15.Sets the total number of probes to be
sent for each test.
Probe Count
Type a number from 0 through 255.Specifies the number of samples to be
used in the statistical calculation
operations to be performed across a
number of the most recent samples.
Moving Average Size
Copyright © 2017, Juniper Networks, Inc.154
J-Web Application Package User Guide for EX Series Switches, Release 14.1X53-A1

Juniper EX Series Specifications

General

Brand	Juniper
Model	EX Series
Category	Switch
Language	English