Juniper EX Series - Page 74

Table 30: Secure Management Access Configuration Summary (continued)
Your ActionFunctionField
To enable SSL access, select the Enable Junos XML
management protocol over SSL check box.
Enables secure SSL access to the Junos
XML management protocol XML
scripting API.
Enable Junos XML
protocol over SSL
To enable an SSL certificate, select a certificate from the
Junos XML management protocol SSL Certificate list—for
example, new.
Specifies SSL certificates to be used for
encryption.
This field is available only after you
create at least one SSL certificate.
Junos XML
managementprotocol
Certificate
To enable HTTP access, select the Enable HTTP access
check box.
Select and clear interfaces by clicking the direction arrows:
•
To enable HTTP access on an interface, add the interface
to the HTTP Interfaces list. You can either select either
all interfaces or specific interfaces.
Enables HTTP access on interfaces.Enable HTTP
To enable HTTPS access, select the Enable HTTPS access
check box.
Select and deselect interfaces by clicking the direction
arrows:
•
To enable HTTPS access on an interface, add the
interface to the HTTPS Interfaces list. You can either
select either all interfaces or specific interfaces.
NOTE: Specify the certificate to be used for HTTPS
access.
Enables HTTPS access on interfaces.Enable HTTPS
Certificates tab
Copyright © 2017, Juniper Networks, Inc.54
J-Web Application Package User Guide for EX Series Switches, Release 14.1X53-A1