[:SENSe[1]]
:FRESistance
:OCOMpensated <b>
:OCOMpensated?
:DCIRcuit <b>
:DCIRcuit?
Enable or disable offset compensation.
Query offset compensation.
Enable or disable dry circuit ohms.
Query dry circuit ohms.
OFF
OFF
√
√
:TEMPerature
:NPLCycles <n>
:NPLCycles?
:REFerence <n>
:STATe <b>
:STATe?
:ACQuire
:REFerence?
:DIGits <n>
:DIGits?
:AVERage
:TCONtrol <name>
:TCONtrol?
:COUNt <n>
:COUNt?
:STATe <b>
:STATe?
:TRANsducer <name>
:TRANsducer
:TCouple
:TYPE <name>
:TYPE?
:RJUNction[1]
:RSELect <name>
:RSELect?
:SIMulated <n>
:SIMulated?
:REAL
:TCOefficient <n>
:TCOefficient?
:OFFSET <n>
:OFFSet?
Path to configure temperature:
Set integration rate (line cycles; 0.01 to 10).
Query line cycle integration rate.
Specify reference (-200 to 1372).
Enable or disable reference.
Query state of reference.
Use input signal as reference.
Query reference value.
Specify measurement resolution (4 to 7).
Query resolution.
Path to configure and control the filter.
Select filter type: (MOVing or REPeat).
Query filter type.
Specify filter count (1 to 100).
Query filter count.
Enable or disable filter.
Query state of digital filter.
Select transducer type (FRTD or TCouple).
Query transducer type.
Path to configure thermocouple:
Select thermocouple type (J, K, T, or N).
Query thermocouple type.
Path to configure reference junction:
Select reference type (SIMulated or REAL).
Query reference type.
Specify simulated temperature in °C (0 to 50).
Query simulated temperature.
Path to configure real reference junction:
Specify temp coefficient (-0.09999 to 0.09999).
Query temp coefficient.
Specify voltage offset at 0°C (-0.09999 to 0.09999).
Query voltage offset.
1
0
OFF
6
(Note)
10
OFF
TCouple
J
SIMulated
23°C
2e-4
5.463e-2
Table 5-6 (cont.)
SENSe command summary
Command Description
Default
parameter
SCPI
SCPI Command Reference 5-15
To Next Page
Loading...
Need help?
General
