SCPI Command Reference 5-63
:DISable <list>
:STATus:QUEue:DISable <list> Disable messages for Error Queue
Parameter <list> = (numlist)
where numlist is a specified list of messages that you wish to disable for the
Error Queue.
Query :DISable? Query list of disabled messages
Description On power-up, all error messages are enabled and will go into the Error Queue
as they occur. Status messages are not enabled and will not go into the queue.
This command is used to specify which messages you want disabled.
Disabled messages are prevented from going into the Error Queue.
Messages are specified by numbers (see Appendix B). See :QUEue:ENABle
for examples to express a numlist.
:CLEar
:STATus:QUEue:CLEar Clears all messages from Error Queue
Description This command is used to clear the Error Queue of all messages.
To Next Page
Loading...
