Model 2700 Multimeter/Switch System User’s Manual Basic DMM Operation 3-17
Current measurements (DCI and ACI)
The Model 2700 can make DCI measurements from 10nA to 3A and ACI measurements
from 1µA to 3A RMS.
NOTE See the previous discussion about crest factor in “Voltage measurements (DCV
and ACV),” page 3-7.
Connections
NOTE When using the front panel inputs, the INPUTS switch must be in the “F” (out)
position. For switching modules, it must be in the “R” (in) position.
WARNING To prevent electric shock, never make or break connections while
power is present in the test circuit.
Front panel inputs
When using the front panel input terminals, connect the test leads to the AMPS and
INPUT LO terminals as shown in
Figure 3-6.
Figure 3-6
DCI and ACI connections using front panel inputs
To Next Page
Loading...
