Keithley 2700 - Wiring Procedure

To Next Page

To Previous Page

B-6 Model 7700 Connection Guide Model 2700 Multimeter/Switch System User’s Manual

Figure B-3

Model 7700 screw terminal channel designations

Wiring procedure

Use the following procedure to wire the Model 7700 module. Make all connections using

correct wire size (up to 20 AWG). Also, make sure to add supplementary insulation

around the harness for voltages above 42V peak (

Figure B-4).

WARNING All wiring and supplementary insulation must be rated for the

maximum voltage in the system. For example, if 1000V is applied to

the front terminals of the DMM, the plug-in module wiring must be

rated for 1000V.

1. Make sure all power is discharged from the Model 7700 module.

2. Access the screw terminals (Figure B-2).

CH7

H L

CH8

H L

CH9

H L

CH10

H L

CH21

H L

CH22

AMPS

H L

CH11

H L

CH12

H L

CH13

H L

CH14

H L

CH15

H L

CH16

H L

CH17

H L

CH18

H L

CH19

H L

CH20

INPUT SENSE

H L H L

CH1

H L

CH2

H L

CH3

H L

CH4

H L

CH5

H L

CH6

H L

SENSE

(OHMS, 4-WIRE)

INPUT

(V, 2-WIRE)