3-8 Basic DMM Operation Model 2700 Multimeter/Switch System User’s Manual
Connections
WARNING Even though the Model 2700 can measure up to 1000V peak, the
maximum input to a switching module is less. Exceeding the voltage
rating of a switching module may cause damage and create a safety
hazard.
NOTE When using the front panel inputs, the INPUTS switch must be in the “F” (out)
position. For switching modules, it must be in the “R” (in) position.
Front panel input
When using the front panel input terminals, connect the test leads to the INPUT HI and
LO terminals as shown in
Figure 3-2.
To Next Page
Loading...
