Model 2700 Multimeter/Switch System User’s Manual Getting Started 1-5
Cables and connector kits for switching modules
Model 7788 DB-50 connector kit — Contains two male DB-50 solder cup connectors
with strain relief connector shells. These connectors mate to the female connectors of the
Models 7703 and 7705 switching modules.
Model 7789 50/25-pin solder cup connector kit — Contains one male DB-50 and one
male DB-25 solder cup connectors. These connectors mate to the female connectors on the
Models 7701 and 7709 switching modules.
Model 7790 ribbon cable adapter kit — Contains one female DB-50, one male DB-50
and one male DB-25 IDC ribbon cable connectors. These connectors are used with the
Models 7701, 7707, and 7709 switching modules.
Model 7051-X — BNC cable (male to male). 7051-2 is 2 ft. long, 7051-5 is 5 ft. long, and
7051-10 is 10 ft. long. These cable are used with the Model 7711 switching module.
Model 7712-SMA-1 — SMA cable (male to male), 1.0m (3.3 ft.) long. This cable is used
with the Models 7711 and 7712 switching modules.
Model 7712-SMA-N — Female SMA to male N-type adapter. This adapter is used with
the Models 7711 and 7712 switching modules.
S46-SMA-X — SMA cable (male to male). S46-SMA-1 is one foot long and
S46-SMA-0.5 is one-half foot long. This cable is used with the Models 7711 and 7712
switching modules.
Cables and adapters (GPIB and trigger link)
Models 7007-1 and 7007-2 shielded GPIB cables — Connect Model 2700 to the GPIB
bus using shielded cables and connectors to reduce electromagnetic interference (EMI).
Model
7007-1 is one meter long; Model 7007-2 is two meters long.
Models 8501-1 and 8501-2 trigger link cables — Connect Model 2700 to other
instruments with Trigger Link connectors (e.g., Model 7002 Switch System).
Model
8501-1 is one meter long; Model 8501-2 is two meters long.
Model 8502 trigger link adapter — Lets you connect any of the six trigger link lines of
Model 2700 to instruments that use the standard BNC trigger connectors.
Model 8503 DIN to BNC trigger cable — Lets you connect trigger link lines one
(Voltmeter Complete) and two (External Trigger) of Model 2700 to instruments that use
BNC trigger connectors. Model 8503 is one meter long.