Model 2700 Multimeter/Switch System User’s Manual Scanning 7-25
2. Press the Δ or ∇ key to display IMM SCAN: N and press ENTER.
a. Press the Δ or ∇ key to enable or disable low limit 1 (LLIM1 SCAN:N/Y),
and press ENTER.
b. Press the Δ or ∇ key to enable or disable high limit 1 (HLIM1 SCAN:N/Y),
and press ENTER.
c. Press the Δ or ∇ key to enable or disable low limit 2 (LLIM2 SCAN:N/Y),
and press ENTER.
d. Press the Δ or ∇ key to enable or disable high limit 2 (HLIM2 SCAN:N/Y),
and press ENTER.
3. Finish configuring the scan by performing Step 4 and Step 5 of the “Advanced scan
setup procedure,” page 7-16.
NOTE For a remote programmed monitor scan, use the ROUTe:MONitor:POINts
command to specify the number of channels to scan (
Table 7-1).
4. While in the normal measurement state, select and enable the monitor channel as
explained in “
Scan configuration — Monitor channel,” page 7-18.
When the reading limit for the monitor channel is reached, the scan will be
triggered to start. When the monitor channel is scanned, the display will show the
reading that triggered the scan.
If the reading limit event is still present on the monitor channel when the scan
finishes, the scan will be triggered to run again. Note that the scan can also be run
by pressing STEP or SCAN.
5. To disable the monitor scan, perform the following steps:
a. To disable monitor, press SHIFT and then MONITOR (MON annunciator
turns off).
b. To disable limits, press SHIFT and then ON/OFF. Press Δ or ∇ to display
“LIMITS: OFF” and press ENTER.
To Next Page
Loading...
Need help?
General
