124 Keysight N9010A EXA Service Guide
Instrument Messages
Condition Errors 201 to 299, Signal Integrity
Condition Errors 201 to 299, Signal Integrity
Errors with the signals being measured: signals not found
(timing/frequency/amplitude), signals noisy or degraded.
An event with the error number shown in the table means the condition has
been detected.
When the condition is cleared, an event with the error number plus 1000 is
generated.
For example, error 207 indicates a Burst Not Found condition has been
detected, error 1207 indicates that failure has been cleared.
An E in the Error or Warning column means that an error is put up on the front
panel and sent out to SCPI when this condition is detected. A W in this column
means that a Warning is put up on the front panel but nothing goes out to
SCPI. Nothing in this column means nothing is put up; status bit only.
Err# Message Error or
Warning
Verbose/Correction Information
203 unused bit0 is set E
205 Degraded Performance E
To Next Page
Loading...
Need help?
General
