80 Keysight N9010A EXA Service Guide
Instrument Messages
Advisory Messages
Advisory Messages
An advisory is simply a message that lets you know something useful - for
example “File saved successfully” or “Measuring fundamental.” Operation
completion and running status indications are common types of advisories.
Advisories have no number and are not logged in the error queue.
Advisories include gray-out “settings conflict” errors. These gray-outs are
benign (i.e. changing them has no impact on the current measurement).
Advisories are event-type errors only. They are never conditions.
Message Description/Correction Information
All Auto/Man functions have been set to
Auto
Dynamic range is not optimum. Set AUTO
RF input.
Exp. Averaging not available when AUTO
PhNoise is active.
Gate required for valid results
Preparing Calculation…
Sync is RF Ampl (not Training
Sequence). Bits are not accurate.
Recalled File <filename> A file recall (open/load) was successfully completed.
Probe connected, no probe cal; using
cable cal data; <port>; <probe>
A probe has been connected and no probe calibration data is
available. The latest cable calibration data will be used
Probe connected, cal data is being
reapplied; <port>; <probe>
A probe has been connected, calibration data is being reapplied
Probe disconnected, reverting to cable
calibration data; <port>
A probe has been disconnected, calibration data reverting to the
last cable calibration data
Connecting to source… External Signal Generator is being sent SCPI commands
interrogating it to see if it is suitable for the MXA to control. Please
wait until complete before pressing any buttons.
Auto sweep time rules do not apply in
FFT sweeps
FFT sweeps do not use the auto sweep time rules, so the rules
setting cannot be changed from the front panel. The setting can be
changed remotely and it will have no effect on the current
operation unless the analyzer is switched out of FFT sweeps.
Filter BW function is only available
for Gaussian filter type
Flattop and CISPR/MIL filters have defined shapes that cannot be
altered. So only the Gaussian filter type allows filter bandwidth
definition changes.
Carrier power is too low for optimum
dynamic range.
For better dynamic range, transmit band spur measurements
require >10 dBm signal power at the RF input port.
To Next Page
Loading...
Need help?
General
