EasyManuals Logo

Keysight Technologies X Series Service Guide

Keysight Technologies X Series
671 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #128 background imageLoading...
Page #128 background image
128 Keysight N9010A EXA Service Guide
Instrument Messages
Condition Errors 201 to 299, Signal Integrity
219 Signal Too Noisy E NADC & PDC: The valid EVM measurement cannot be
performed, because the input signal is too noisy.
GSM & EDGE: In a GSM measurement, indicates that a
burst could not be found in a signal that appears noisy.
221 Slot Error E
221 Slot Error; No idle
slot found
E No valid idle slot found in captured data, or no idle slot
found in captured interval. Synchronization may succeed
and pilot found when this message is issued, but no results
are included in peak/average calculation.
221 Slot error;No active
slot found
E No valid active slot found in captured data, or no active slot
found in captured interval. Synchronization may succeed
and pilot found when this message is issued, but no results
are included in peak/average calculation.
223 unused bit10 is set E
225 unused bit11 is set E
227 unused bit12 is set E
229 unused bit13 is set E
231 unused bit14 is set E

Table of Contents

Other manuals for Keysight Technologies X Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Keysight Technologies X Series and is the answer not in the manual?

Keysight Technologies X Series Specifications

General IconGeneral
BrandKeysight Technologies
ModelX Series
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals