WARNING
Never attempt to operate the driver
position memory system while the
vehicle is moving.
This could result in loss of control,
and an accident causing death, seri‐
ous injury, or property damage.
Storing positions into memory
using the buttons on the door
Storing driver's seat positions
1. Shift the shift lever into P (for Au‐
tomatic transaxle/Dual clutch
transmission) or Neutral (for man‐
ual transaxle) while the engine
start/stop button is ON or ignition
switch ON.
2. Adjust the driver’s seat and outside
rearview mirror comfortable for
the driver.
3. Press SET button on the control
panel. The system will beep once.
4. Press one of the memory buttons
(1 or 2) within 5 seconds after
pressing the SET button. The sys‐
tem will beep twice when memory
has been successfully stored.
Recalling positions from memory
1. Shift the shift lever into P (for Au‐
tomatic transaxle/Dual clutch
transmission) or Neutral (for man‐
ual transaxle) while the engine
start/stop button is ON or ignition
switch ON.
2. To recall the position in the memo‐
ry, press the desired memory but‐
ton (1 or 2). The system will beep
once, then the driver’s seat will au‐
tomatically adjust to the stored po‐
sition.
Adjusting the control switch for the
driver’s seat while the system is recall‐
ing the stored position will cause the
movement to stop and move in the di‐
rection that the control switch is
moved.
WARNING
Use caution when recalling the ad‐
justment memory while sitting in
the vehicle. Push the seat position
control switch to the desired position
immediately if the seat moves too
far in any direction.
Easy access function (if equipped)
The system will move the driver's seat
automatically as follows:
• Without smart key system:
- It will move the driver’s seat rear‐
ward when the ignition key is re‐
moved and front driver’s door is
opened.
- It will move the driver’s seat for‐
ward when the ignition key is in‐
serted.
• With smart key system:
- It will move the driver’s seat rear‐
ward when the engine start/stop
button is changed to the OFF posi‐
tion and front driver’s door is
opened.
- It will move the driver’s seat for‐
ward when the engine start/stop
button is changed to the ACC or
START position.
- It will move the driver's seat for‐
ward when you get in your vehicle
with the smart key after closing
the driver's door.
You can activate or deactivate this fea‐
ture. Refer to User settings on page
4-71.
3-09
3
Safety features of your vehicle
To Next Page
Loading...
