Kia Optima 2017 - License Plate Light Bulb Replacement; High Mounted Stop Lamp Bulb Replacement

9. Install the socket in the assembly
by aligning the tabs on the socket
with the slots in the assembly.
Push the socket into the assembly
and turn the socket clockwise.
10. Install the rear combination lamp
(inside) assembly to the body of
the vehicle.
11. Install the trunk lid cover.
License plate light bulb
replacement (Sedan)
OJF075081
1. Open the trunk lid.
2. Loosen the retaining screw of the
trunk lid cover and then remove the
cover.
OJF075085
3. Remove the socket from the as‐
sembly by turning the socket coun‐
terclockwise until the tabs on the
socket align with the slots on the
assembly.
4. Remove the bulb from bulb-socket
by pulling it out.
5. Insert a new bulb by inserting it in‐
to the bulb-socket.
6. Install the socket in the assembly
by aligning the tabs on the socket
with the slots in the assembly.
Push the socket into the assembly
and turn the socket clockwise.
7. Install the trunk lid cover.
High mounted stop lamp bulb
replacement (Sedan)
OJF075049
If the high mounted stop lamp (LED)
does not operate, we recommend that
you checked an authorized Kia dealer.
8-117
8
Maintenance