5. Remove the rear combination lamp
assembly from the body of the ve‐
hicle.
6. Remove the socket from the as‐
sembly by turning the socket coun‐
terclockwise until the tabs on the
socket align with the slots on the
assembly.
7. Remove the bulb from the socket
by pressing it in and rotating it
counterclockwise until the tabs on
the bulb align with the slots in the
socket. Pull the bulb out of the
socket.
8. Insert a new bulb by inserting it in‐
to the socket and rotating it until it
locks into place.
9. Install the socket in the assembly
by aligning the tabs on the socket
with the slots in the assembly.
Push the socket into the assembly
and turn the socket clockwise.
10. Install the rear combination lamp
assembly to the body of the vehi‐
cle.
11. Install the service cover by putting
it into the service hole.
Stop and tail lamp (LED type)
bulb replacement (Sedan)
If the stop and tail lamp (LED) does not
operate, we recommend that you
checked an authorized Kia dealer.
8-113
8
Maintenance
To Next Page
Loading...
