11.FINAL REDUCTION/
TRANSMISSION SYSTEM
11-5
MXU 500
Using a chisel, unlock the nut.
Hold the driven pulley by using the special
tool (refer to the “DRIVE PULLEY, DRIVE
V-BELT AND DRIVEN PULLEY
REMOVAL/INSPECTION/INSTALLATIO
N” section in the chapter 10), then remove
the nut.
Special tool:
Y-type holder A120E00056
Remove the secondary drive bevel gear.
Remove the shim.
INSPECTION
Check the drive/driven bevel gear teeth for
pitting, galling and wear.
Secondary Drive Bevel Gear/Shi
To Next Page
