DVR Settings
Entering/Changing the Wireless Options
Flashback3 & Flashback HD User’s Guide
Page 152 L3 Mobile-Vision 6.23.2017
9 To
enter/change the first segment of the IP address, proceed to the next step.
Otherwise use the button to advance to the first segment you wish to change.
10 If
the current value of this IP segment is 0, proceed to the next step.
– OR –
If the current value of this IP segment is 1 – 255, use the or
buttons to move
the numeric display higher or lower, respectively. Next, skip to step 12.
11 Press . The number 255 displays. Keep pressing the button until the desired
number displays. (If you overshoot the number, press to back up.)
12 Use t
he button to advance to the next segment you wish to enter/change.
13 Rep
eat steps 10 – 12 until all four segments of the IP address are entered/updated.
14 Press four times to save your changes and exit this option.
Entering/Changing the Wireless Gateway IP
This section describes how to enter or change the gateway address for the DVR’s
wireless network interface card (NIC). This value is usually set to the IP of the
storage server.
NO
TE: If you want your DHCP server to automatically provide the wireless IP
addresses to this DVR, do not enter this field. Instead, turn the Wireless DHCP
option on, as described in “Turning the Wireless DHCP Option On/Off” on page 155.
1 Ma
ke sure the door to your DVR is open and Auto mode is off. (If necessary, press
the button until the light turns off.)
2 Pr
ess . The Main Menu displays.
To Next Page
Loading...
