Flashback3 & Flashback HD User’s Guide
Page vi L3 Mobile-Vision 6.23.2017
Important Safeguards
This symbol indicates important operating and maintenance instructions.
This symbol indicates un-insulated “dangerous voltage” within the product’s enclo-
sure that may be of sufficient magnitude to constitute a risk of electric shock to a person.
Caution: This system is designed to operate in 12 volt DC negative ground vehicles only. All
system components must be operated only when properly connected to the DVR.
Attention: To reduce the risk of electric shock, do not perform any servicing other than
that contained in this User’s Guide unless you are qualified to do so. Refer all servicing to
qualified personnel.
DO NOT block ventilation openings.
DO NOT allow liquids to enter the DVR or any other component of the Flashback. This could
cause electrical shorts, fire, or other damage.
The Flashback should be installed by a qualified technician and must conform to SAE
Requirements. Ground wires (black) must be connected to the vehicle’s chassis. Never
connect ground wires to the vehicle’s battery. If your vehicle also has a mobile data
computer, make sure that both devices are grounded at the exact same point.
Warning: Airbag Deployment—Do not install equipment or route wiring in the deployment
path of an airbag. Failure to observe this warning will reduce the effectiveness of the airbag
or potentially dislodge the equipment, causing serious injury.
Warning: Seat Removal Precaution—If a vehicle seat is temporarily removed, verify with the
vehicle manufacturer if the seat needs to be recalibrated for proper airbag deployment.
Failure to heed this warning could result in death or serious injury.
Notice: Drilling Precautions—When drilling holes, check the area in which you are drilling to
be sure you do not damage vehicle components. All drilled holes should be deburred and all
sharp edges should be smoothed. All wire routings going through drilled holes should be
protected by a grommet or convolute/split loom tubing.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
!
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
To Next Page
Loading...