DVR Settings
Entering/Changing the Ethernet Options
Flashback3 & Flashback HD User’s Guide
L3 Mobile-Vision 6.23.2017 Page 161
9 Press . The number 255 displays. Keep pressing the button until the desired
number displays. (If you overshoot the number, press to back up.)
10 Use the button to advance to the next segment you wish to enter/change.
11 Repeat steps 8 – 10 until all four segments of the IP address are entered/updated.
12 P
ress four times to save your changes and exit this option.
Entering/Changing the Ethernet NetMask
This section describes how to enter or change the netmask IP address for the internal
Ethernet LAN interface. For more information on when/why you might need to
update this field, see “Entering/Changing the Ethernet Options” on page 158.
W
ARNING: If you are using both a wireless network and an Ethernet network, each
NetMask must be unique. You cannot use the same NetMask for both networks!
NOTE: If you want your DHCP server to automatically provide the Ethernet
addresses to this DVR, do not enter this field. Instead, turn the Ethernet DHCP option
on, as described in “Turning the Ethernet DHCP Option On/Off” on page 169.
1 M
ake sure the door to your DVR is open and Auto mode is off. (If necessary, press
the button until the light turns off.)
2 P
ress . The Main Menu displays.
3 P
ress the or button until Network is highlighted.
To Next Page
Loading...
