DVR Settings
Entering/Changing the Wireless Options
Flashback3 & Flashback HD User’s Guide
L3 Mobile-Vision 6.23.2017 Page 155
9 To
enter/change the first segment of the IP address, proceed to the next step.
Otherwise use the button to advance to the first segment you wish to change.
10 If
the current value of this IP segment is 0, proceed to the next step.
– OR –
If the current value of this IP segment is 1 – 255, use the or
buttons to move
the numeric display higher or lower, respectively. Next, skip to step 12.
11 Press . The number 255 displays. Keep pressing the button until the desired
number displays. (If you overshoot the number, press to back up.)
12 Use t
he button to advance to the next segment you wish to enter/change.
13 Rep
eat steps 10 – 12 until all four segments of the IP address are entered/updated.
14 Pr
ess four times to save your changes and exit this option.
Turning the Wireless DHCP Option On/Off
This section describes how to turn the wireless DHCP wireless option on/off. If this
option is on, your DHCP server will automatically provide the wireless IP addresses
to this DVR, overriding the values in the IP Address, NetMask, and Gateway fields.
If this option is off, you will have to manually assign IP addresses to this DVR by
entering the IP Address, NetMask, and Gateway fields on the Wireless screen.
1 Ma
ke sure the door to your DVR is open and Auto mode is off. (If necessary, press
the button until the light turns off.)
2 Pr
ess . The Main Menu displays.
To Next Page
Loading...
