Changing the Flashback Monitor Settings
Adjusting the Text Transparency of the Monitor Controls
Flashback3 & Flashback HD User’s Guide
L3 Mobile-Vision 6.23.2017 Page 239
1 P
ress + simultaneously to enter Monitor Setup Mode. The yellow Contrast
bar displays at the bottom of your monitor.
N
OTE: If the red DIMMER display appears rather than the CONTRAST display
pictured above, it means that you accidentally pressed the button slightly ahead of
the
button. Wait until the display disappears, then trying pressing + again.
2 P
ress four times to advance to the Sharpness bar.
3 U
se the button to increase this setting in increments of five.
– OR –
Use the button to decrease this setting in increments of five.
A
fter several seconds of inactivity, the system will automatically exit Monitor
Setup Mode.
Adjusting the Text Transparency of the Monitor Controls
This section describes how to increase/decrease the transparency of the text that
displays on-screen when the monitor controls are activated (i.e., volume display,
brightness display, etc.) This setting does not affect any other on-screen text, such as
the officer name or GPS coordinates. It only affects the on-screen controls, such as
the “Contrast” display pictured below.
B
efore you change this setting, it’s recommended that you turn the GPS monitor
display off, as it will make it difficult for you to see the Alpha Blanding bar. For
instructions, see “Turning the ‘GPS’ Display On/Off” on page 138.
1 P
ress + simultaneously to enter Monitor Setup Mode. The yellow Contrast
bar displays at the bottom of your monitor.
N
OTE: If the red DIMMER display appears rather than the CONTRAST display
pictured above, it means that you accidentally pressed the button slightly ahead of
the
button. Wait until the display disappears, then trying pressing + again.
To Next Page
Loading...