Lexmark C925 - Reset Separator Roll and Pick Assembly Counter; Reset Maintenance Counter; Reset Fuser Counter; Reset Transfer Belt Counter

3-8 Service Manual
5041-030
Go Back
Previous
Next
Reset Separator Roll and Pick Assembly Counter
Use this menu setting to reset the paperfeed assembly counter after changing out the paperfeed rolls, or the
paperfeed unit.
Reset Maintenance Counter
This menu item is used to reset the maintenance counter for the print engine.
1. Touch the menu item. A “Reset Maintenance Counter” button is displayed.
2. Touch that button to reset the counter.
Reset Fuser Counter
This menu item is used to reset the fuser counter for the print engine.
1. Touch the menu item. A “Reset Fuser Counter” button is displayed.
2. Touch that button to reset the counter.
Reset Transfer Belt Counter
This menu item is used to reset the fuser counter for the print engine.
1. Touch the menu item. A “Reset Fuser Counter” button is displayed.
2. Touch that button to reset the counter.
Black Only Mode
When this setting is set to On the printer prints only grayscale printing. The default is Off. The result is similar to
setting Print Mode to Black Only.
Note: This setting appears only when the PJL Password Environment variable is set to 0.
Disk Encryption See “Disk Encryption” on page 3-12.
Erase all information on Disks See “Erase all information on Disks” on page 3-12.
Wipe All Settings See “Wipe All Settings” on page 3-12.
Font Sharpening See “Font Sharpening” on page 3-12.
Require Standby See “Require Standby” on page 3-12.
Key Repeat Initial Delay See “Key Repeat Initial Delay” on page 3-13.
Key Repeat Rate See “Key Repeat Rate” on page 3-13.
Clear Custom Status See “Clear Custom Status” on page 3-13.
USB Speed See “USB Speed” on page 3-13.
USB PnP See “USB PnP” on page 3-13.
Automatically Display Error
Screens
See “Automatically Display Error Screens” on page 3-13.
Exit Config Menu See “Exit Config Menu” on page 3-13.
Configuration Menu