2-94 Finisher Service Manual
4024-XXX
Stacker media bin full (mix size)
4 Perform a test print.
Does the error still occur?
Replace the
finisher controller
card assembly.
Go to “Finisher
controller card
assembly
removal” on
page 4-118.
Problem solved.
Step Check Yes No
1 Check the stacker bin for obstructions.
Are there any obstructions on the upper and lower
parts of the stacker bin?
Remove the
obstructions.
Go to step 2.
2 Check the sensor (stacker bin level 1) for correct
operation.
Perform the sensor (stacker bin level 1) test.
1. Enter Diagnostics mode.
2. Select FINISHER TESTS.
3. Select Sensor Tests.
4. Select Bin Level.
5. Select Stacker bin level1.
Does the display on the operator panel change every
time the sensing area of the sensor (stacker bin level 1)
is blocked by a multi page document or your finger?
Go to step 4. Go to step 3.
3 Is the sensor (stacker bin level 1) connected properly? Replace the
sensor (stacker
bin level 1). Go to
“Sensor
(stacker bin
level 1)
removal” on
page 4-34.
Replace the
connection.
4 Check the sensor (stacker bin level 2) for correct
operation.
Perform the sensor (stacker bin level 2) test.
1. Enter Diagnostics mode.
2. Select FINISHER TESTS.
3. Select Sensor Tests.
4. Select Bin Level.
5. Select Stacker bin level2.
Does the display on the operator panel change every
time the sensing area of the sensor (stacker bin level
rear) is blocked by a multi page document or your
finger?
Go to step 6. Go to step 5.
Step Check Yes No
To Next Page
Loading...
