4-108 Finisher Service Manual
4024-XXX
Sensor (upper media bin full) removal
1. Open the finisher front door assembly.
2. Remove the screw securing the bracket (A) to the upper media bin vertical cover (B).
3. Move the bracket frontward and downward to gain access to the harness and connector.
4. Release the harness from the clamp.
5. Move the bracket (B) frontward again, and remove the screw securing the sensor (upper media bin full) (C)
to the bracket.
6. Remove the sensor (upper media bin full) (C).
7. Disconnect the connector from the sensor (upper media bin full) (C).
Front
C
Harness clamp
A
Front
B
A
To Next Page
Loading...
