4-54 Finisher Service Manual
4024-XXX
Stapler unit frame removal
1. Remove the finisher front door assembly. See “Finisher front door assembly removal” on page 4-27.
2. Remove the staple cartridge.
3. Remove the rear upper cover. See “Rear upper cover removal” on page 4-24.
4. Remove the rear lower cover. See “Rear lower cover removal” on page 4-23.
5. Loosen the four screws securing the plate (A) to the finisher.
6. Move the plate (A) toward the right and out in the direction shown.
7. Remove the plate.
To Next Page
Loading...
