4-26 Finisher Service Manual
4024-XXX
Switch (finisher front door interlock) removal
1. Open the finisher front door assembly.
2. Remove the rear upper cover. See “Rear upper cover removal” on page 4-24.
3. Remove the punch waste box (A).
4. Remove the three screws in the front securing the punch waste chute (B).
5. Gently pull down the punch waste chute (B) to gain better access to the switch (finisher front door
interlock) (C).
6. Disconnect the connector from the switch (finisher front door interlock) (C).
7. Release the hooks securing the switch (finisher front door interlock) (C) to the finisher.
8. Remove the switch (finisher front door interlock) (C).
To Next Page
Loading...
