Repair information 4-47
4024-XXX
Punch unit motor assembly removal
1. Open the finisher front door assembly.
2. Remove the rear upper cover. See“Rear upper cover removal” on page 4-24.
3. Remove the punch carriage assembly. See “Punch carriage assembly removal” on page 4-41.
4. Disconnect the connector from the punch unit motor assembly (A).
5. Disconnect the connector from the sensor (punch unit motor encoder) (B).
6. Remove the harness from the clamp.
7. Remove the two screws securing the punch unit motor assembly (A) to the punch unit assembly (C).
8. Remove the punch unit motor assembly.
To Next Page
Loading...
