4-12 Finisher Service Manual
4024-XXX
Bridge unit transport belt removals
1. Remove the bridge unit rear cover. See “Bridge unit rear cover removal” on page 4-6.
2. Open the bridge unit top cover assembly.
3. Remove the bridge unit right shaft assembly. See “Bridge unit right shaft assembly removal” on
page 4-9.
4. Remove the bridge unit left shaft assembly. See “Bridge unit left shaft assembly removal” on
page 4-10
5. Remove the bridge unit idler rolls. See “Bridge unit idler rolls removal” on page 4-11.
6. Remove the transport belts (A) from the bridge unit assembly (B).
To Next Page
Loading...
