2-2 Finisher Service Manual
4024-XXX
Confirm the installation status
Be sure to check the following items before starting the troubleshooting procedures
• With the power cord removed from the printer, check that it is free from breakage, short-circuit,
disconnected wire, or incorrect connection in the power cord.
• The printer is properly grounded. Check the power cord ground terminal.
• The printer is not installed at a place subjected to extreme temperature, or extreme humidity, or rapid
changes in temperature.
• The printer is not installed close to water service, humidifier, heat generating unit, fire, in a very dusty
place, or a place exposed to air flow from the air conditioning system.
• The printer is not installed in a place where volatile gas or inflammable gas is generated.
• The printer is not installed in direct sun.
• The printer is installed on a stout and stable surface.
• Media meets specifications and is installed properly.
• Customer maintenance parts have been replaced at the specified intervals.
• Check all attached options for proper attachment and electrical connection.
• Refer to the User’s Guide for proper installation.
To Next Page
Loading...
