2-74 Finisher Service Manual
4024-XXX
984.01 Sensor (punch unit HP) off failure
Step Check Yes No
1 Check the punch unit by moving it with your fingers.
Does the punch unit move smoothly?
Go to step 2. Remove
obstructions.
2 Check the sensor (punch unit HP) for correct operation.
Perform the sensor (punch unit HP) test.
Remove the rear upper cover. Go to “Rear upper
cover removal” on page 4-24.
1. Enter Diagnostics mode.
2. Select FINISHER TESTS.
3. Select Sensor Tests.
4. Select Punch and Staple.
5. Select Punch unit HP.
Move the rack gear in the punch unit assembly
manually by hand.
Does the display on the operator panel change every
time the sensing area of the sensor (punch unit HP) is
blocked?
Go to step 4. Go to step 3.
3 Is the sensor (punch unit HP) and punch sensor cable
assembly connected properly?
Replace the
sensor (punch
unit HP). Go to
“Sensor (punch
hole select),
sensor (punch
cam front), and
sensor (punch
unit HP)
removal” on
page 4-49.
Replace the
connection.
4 Check the punch unit motor for correct operation.
Perform the 2 punch test.
Remove the rear upper cover. Go to “Rear upper
cover removal” on page 4-24.
1. Enter the Diagnostic mode.
2. Select FINISHER TESTS.
3. Select Hole Punch Test.
4. Select 2 Punch test.
Does the punch unit motor rotate normally and punch
holes in the media?
Go to step 6. Go to step 5.
5 Is the punch unit motor and punch drive cable
assembly connected properly?
Replace the
punch unit motor.
Go to “Punch
unit motor
assembly
removal” on
page 4-47.
Replace the
connection.
To Next Page
Loading...
