Repair information 4-35
4024-XXX
Sensor (stacker bin level encoder) removal
1. Remove the rear upper cover. See“Rear upper cover removal” on page 4-24.
2. Disconnect the connector from the sensor (stacker bin level encoder) (A).
3. Release the harness from the clamp.
4. Remove the screw securing the bracket (B) from the stacker bin lift motor assembly (C).
5. Release the hooks securing the sensor to the bracket (B).
6. Remove the sensor (stacker bin level encoder) (A).
A
B
C
Rear
Clamp
Clamp
Connector
To Next Page
Loading...
