Lexmark W850 - Clamp Paddle Removal

4-76 Finisher Service Manual
4024-XXX
Clamp paddle removal
1. Remove the finisher front door assembly. See “Finisher front door assembly removal” on page 4-27.
2. Remove the rear upper cover. See “Rear upper cover removal” on page 4-24.
3. Remove the media eject shaft assembly. See “Media eject shaft assembly removal” on page 4-74.
4. Remove the three clamp paddles (A) by sliding them out of the media eject shaft assembly (B).
Replacement note: Replacement is easier if you lightly moisten the rubber surface of the paddles with water.
A
Narrow
Wide
B
Right
A