Lexmark W850 - Bridge Unit Drive Belt and Bridge Unit Drive Pulley Removal

4-8 Finisher Service Manual
4024-XXX
Bridge unit drive belt and bridge unit drive pulley removal
1. Remove the bridge unit rear cover. See “Bridge unit rear cover removal” on page 4-6.
2. Remove the e-clip with a prying tool securing the bridge unit drive pulley (A) to the bridge unit
assembly (B).
3. Remove the bridge unit drive pulley (A) and the bridge unit drive belt (C) from the bridge unit assembly (B).
Replacement note: Make sure to install the bridge unit drive pulley (A) to the bridge unit assembly in the
direction shown.
B
A
C
Install this surface facing outside.
Recessed key