3-4 Finisher Service Manual
4024-XXX
Theory
Media transport
This section describes transfer of media from the printer to a specified bin.
The following figures illustrate layouts (side view viewing from the front side) of sensors, rollers, and main blocks,
as well as a layout (rear view) of the main components.
Bridge unit assembly paper path
Finisher media path
To finisher
From printer
Transport
belt
Sensor (bridge unit
media exit)
Sensor (bridge unit media entrance)
Compiler media
unit assembly
Stapler unit
Punch unit
From
bridge unit
Upper media bin
Stacker media bin
To Next Page
Loading...
