Lexmark W850 - Sensor (Compiler Media In) Static Jam

Diagnostic information 2-43
4024-XXX
286.00 Sensor (compiler media in) static jam
5 Check the sensor (compiler media in) for correct
operation.
Perform the sensor (compiler media in) in test.
1. Enter Diagnostics mode.
2. Select FINISHER TESTS.
3. Select Sensor Tests.
4. Select Media Path1.
5. Select Compiler media in.
Does the display on the operator panel change every
time the compiler media in actuator of the sensor
(compiler media in) is operated?
Go to step 7. Go to step 6.
6 Check the sensor (compiler media in) connection.
Are the connections of the compiler unit cable
assembly properly connected?
Replace the
sensor (compiler
media in). Go to
“Sensor
(compiler media
in) removal” on
page 4-73.
Replace the
connection.
7 Perform a test print. Does the error still occur? Replace the
finisher controller
card assembly.
Go to “Finisher
controller card
assembly
removal” on
page 4-118.
Problem solved
Step Check Yes No
1 Check the eject clamp motor for correct operation.
Check the above motor by opening the finisher front
door assembly and then closing it.
Does the eject clamp motor rotate normally?
Go to step 3. Go to step 2.
2 Check the eject clamp motor connection.
Are the connections of the main drive cable assembly
correctly connected?
Replace the eject
clamp motor. Go
to “Media eject
clamp motor
assembly
removal” on
page 4-66.
Replace the
connector.
3 Check the sensor (compiler media in) for correct
operation.
Perform the sensor (compiler media in) test.
1. Enter Diagnostics mode.
2. Select FINISHER TESTS.
3. Select Sensor Tests.
4. Select Media Path1.
5. Select Compiler media in.
Does the display on the operator panel change every
time the actuator of the sensor (compiler media in) is
operated?
Go to step 5. Go to step 4.
Step Check Yes No