Lexmark W850 - Sensor (Media Eject Shaft HP) Removal

Repair information 4-79
4024-XXX
Sensor (media eject shaft HP) removal
1. Remove the rear upper cover. See “Rear upper cover removal” on page 4-24.
2. Disconnect the connector from the sensor (media eject shaft HP) (A).
3. Rotate the media eject clutch actuator (B) by hand so it clears the sensor (media eject shaft HP) (A).
4. Release the hooks securing the sensor (media eject shaft HP) (A) to the bracket (C).
5. Remove the sensor (media eject shaft HP) (A).
Rear
B
A
C
Connector