Repair information 4-115
4024-XXX
Drive motor (buffer/transport) and belt (buffer/transport) removal
1. Remove the rear upper cover. See “Rear upper cover removal” on page 4-24.
2. Remove the two screws securing the bracket (A) on the rear of the finisher.
3. Move the bracket slightly.
Note: It is not necessary to remove the bracket from the finisher. It should only be slightly moved to
provide better access to the drive motor (buffer/transport) (B) for removal.
4. Loosen the two screws securing the belt tensioner bracket (C) to the finisher, and move it down as shown.
5. Remove the belt (buffer/transport) (D) from the drive motor (buffer/transport).
To Next Page
Loading...
