4-82 Finisher Service Manual
4024-XXX
Lower media exit roll assembly removal
1. Remove the finisher front door assembly. See “Finisher front door assembly removal” on page 4-27.
2. Remove the rear upper cover. See “Rear upper cover removal” on page 4-24.
3. Remove the upper media bin assembly. See “Upper media bin assembly removal” on page 4-20.
4. Remove upper media bin vertical cover. See “Right eject cover removal” on page 4-21.
5. Remove the stapler unit frame. See “Stapler unit frame removal” on page 4-54.
6. Remove the media eject clamp motor assembly. See “Media eject clamp motor assembly removal” on
page 4-66.
7. Remove the media eject unit assembly. See “Media eject unit assembly removal” on page 4-59.
8. Remove the media compiler unit assembly. See “Media compiler unit assembly removal” on
page 4-69.
9. Remove the media eject motor assembly. See “Media eject motor assembly removal” on page 4-78.
10. Remove the media eject shaft assembly. See “Media eject shaft assembly removal” on page 4-74.
11. Remove the main paddle shaft assembly. See “Paddle and roll exit assembly removal” on page 4-86.
12. Loosen the two screws securing the belt tensioner bracket (A) to the finisher, and move it down in the
direction of the arrow.
13. Remove the belt (exit) (B) from the lower exit roll drive pulley 20T (C).
A
B
C
A
Tighten
first
Tighten
second
Rear
To Next Page
Loading...
