Diagnostic aids 3-1
4024-XXX
3. Diagnostic aids
This chapter explains the finisher tests and procedures and information to identify finisher failures and verify
repairs have corrected the problem. Refer to the Printer Service Manual for the entire Diagnostics mode and
Configuration menus. Also descriptive information in “Theory” on page 3-4 explains the processes and is
helpful in understanding the finisher.
Diagnostics are built into the printer RIP card assembly and can be accessed from the printer operator panel.
Accessing Diagnostics mode
There are different test menus that can be accessed during POR to identify problems with the printer.
To run the printer diagnostic tests described in this chapter, you must put the printer in Diagnostics mode.
Available finisher tests
This is a partial list of the tests available to the printer. Details below are for the finisher, only. The tests display
on the operator panel in the order shown:
Diagnostics mode 1. Turn off the printer
2. Press and hold and .
3. Turn on the printer.
4. Release the buttons when the
clock face appears.
The Diagnostics mode group contains the settings
and operations used while manufacturing and
servicing the printer and finisher.
See“Available finisher tests” on page 3-1 for
more information.
Finisher tests from Diagnostics mode
FINISHER TESTS
Staple Test See “Staple Test” on page 3-2
Hole Punch Test See “Hole Punch Test” on page 3-2
Feed Tests See “Feed Tests” on page 3-2
Sensor Test See “Sensor Test (finisher)” on page 3-2
Cover and Door
Bin Level
Media Path1
Media Path2
Punch and Staple
To Next Page
Loading...
