4-96 Finisher Service Manual
4024-XXX
Buffer pinch guide assembly removal
1. Remove the finisher front door assembly. See “Finisher front door assembly removal” on page 4-27.
2. Remove the rear upper cover. See “Rear upper cover removal” on page 4-24.
3. Remove the stapler unit frame. See “Stapler unit frame removal” on page 4-54.
4. Lower the buffer pinch guide assembly (A) as far as it will go.
5. Move the buffer pinch guide assembly (A) to the right to remove the two bosses from the holes in the
finisher.
To Next Page
Loading...
