Lexmark W850 - Sensor (Stacker bin Level 1) Removal; Sensor (Stacker bin Level 2) Removal

4-34 Finisher Service Manual
4024-XXX
Sensor (stacker bin level 1) removal
1. Remove the finisher front door assembly. See “Finisher front door assembly removal” on page 4-27.
2. Remove the rear upper cover. See “Rear upper cover removal” on page 4-24.
3. Disconnect the connector from the sensor (stacker bin level 1) (A).
4. Remove the screw securing the sensor (stacker bin level 1) (A) to the finisher.
5. Remove the sensor (stacker bin level 1) (A).
Sensor (stacker bin level 2) removal
1. Remove the finisher front door assembly. See “Finisher front door assembly removal” on page 4-27.
2. Remove the rear upper cover. See “Rear upper cover removal” on page 4-24.
3. Disconnect the connector from the lift tray height sensor (stacker bin level 2) (A).
4. Remove the screw securing the sensor (stacker bin level 2) (A).
5. Remove the sensor (stacker bin level 2) (A).
Front
A
Connector
A
Rear
Connector