2-96 Finisher Service Manual
4024-XXX
Stacker media bin full (no mix)
Step Check Yes No
1 Check the stacker bin for obstructions.
Are there any obstructions on the upper and lower
parts of the stacker bin?
Remove the
obstructions.
Go to step 2.
2 Check the sensor (stacker bin level 1) for correct
operation.
Perform the sensor (stacker bin level 1) test.
1. Enter Diagnostics mode.
2. Select FINISHER TESTS.
3. Select Sensor Tests.
4. Select Bin Level.
5. Select Stacker bin level1.
Does the display on the operator panel change every
time the sensing area of the sensor (stacker bin level 1)
is blocked by a multi page document or your finger?
Go to step 4. Go to step 3.
3 Is the sensor (stacker bin level 1) installed correctly? Replace the
sensor (stacker
bin level 1). Go to
“Sensor
(stacker bin
level 1)
removal” on
page 4-34.
Replace the
connection.
4 Check the sensor (stacker bin level 2) for correct
operation.
Perform the sensor (stacker bin level 2) test.
1. Select Diagnostics mode.
2. Select FINISHER TESTS,.
3. Select Sensor Tests.
4. Select Bin Level.
5. Select Stacker bin level2.
Does the display on the operator panel change every
time the sensing area of the sensor (stacker bin level
rear) is blocked by blocked by a multi page document
or your finger?
Go to step 5. Go to step 6.
5 Is the sensor (stacker bin level 2) connected properly? Replace the
sensor (stacker
bin level 2). Go to
“Sensor
(stacker bin
level 2)
removal” on
page 4-34.
Replace the
connection.
6 Check the encoder of the sensor (stacker bin level
encoder) installation.
Is the encoder installed correctly?
Does it enter the detection point of the sensor (stacker
bin level encoder)?
Go to step 7. After reinstalling,
go to step 7.
To Next Page
Loading...
