2-68 Finisher Service Manual
4024-XXX
982.00 Sensor (front tamper HP) on failure
8 Check the sensor (stacker bin level encoder) for correct
operation.
Perform the sensor (stacker bin level encoder) test.
1. Enter Diagnostics mode.
2. Select FINISHER TESTS.
3. Select Sensor Tests.
4. Select Bin Level.
5. Select Stacker bin level encod.
Does the display on the operator panel change when
the belt of the stacker bin lift motor assembly is moved
by hand?
Go to step 10. Go to step 9.
9 Is the sensor (stacker bin level encoder) connected
properly?
Replace the
sensor (stacker
bin level
encoder). Go to
“Sensor
(stacker bin
level encoder)
removal” on
page 4-35.
Replace the
connection.
10 Check the stacker bin lift motor assembly by blocking
the lower hole in either of the sensor (stacker bin level).
The stacker bin should lower slightly.
Does the stacker bin lift motor assembly rotate
normally?
Go to step 12. Go to step 11.
11 Check the stacker bin lift motor assembly connection.
Is the connector of the stacker bin lift motor assembly
correctly connected to the finisher controller card
assembly?
Replace the
stacker bin lift
motor assembly.
Go to “Stacker
bin lift motor
assembly
removal” on
page 4-38.
Replace the
connection.
12 Perform a test print.
Does the error still occur?
Replace the
finisher controller
card assembly.
Go to “Finisher
controller card
assembly
removal” on
page 4-118.
Problem solved.
Step Check Yes No
1 Check the tamper mechanism by moving it with your
fingers.
Does the tamper mechanism operate smoothly?
Go to step 2. Replace the
media compiler
unit assembly. Go
to “Media
compiler unit
assembly
removal” on
page 4-69.
Step Check Yes No
To Next Page
Loading...
