Repair information 4-103
4024-XXX
Buffer diverter gate solenoid removal
1. Open the finisher front door assembly.
2. Remove the rear upper cover. See “Upper media bin front cover removal” on page 4-25.
3. Disconnect the connector from the buffer diverter gate solenoid (A).
4. Release the harness from the clamp.
5. Remove the two screws securing the buffer diverter gate solenoid to the finisher.
6. Remove the buffer diverter gate solenoid.
Note: The link (B) may remain inserted into the finisher.
7. Remove the link.
Note: When the link is removed, the buffer diverter gate may become detached. See “Buffer diverter
gate removal” on page 4-92.
To Next Page
Loading...
