4-56 Finisher Service Manual
4024-XXX
Stapler unit assembly removal
1. Remove the finisher front door assembly. See “Finisher front door assembly removal” on page 4-27.
2. Remove the staple cartridge.
3. Remove the rear upper cover. See “Rear upper cover removal” on page 4-24.
4. Remove the rear lower cover. See “Rear lower cover removal” on page 4-23.
5. Remove the stapler unit frame. See “Stapler unit frame removal” on page 4-54.
6. Remove the five screws securing the stapler unit frame (A) to the plate (B).
7. Remove the stapler unit frame (A).
8. Release the harness from the three clamps on the stapler unit frame (A).
9. Remove the two screws securing the stapler carriage motor assembly (C) to the stapler carriage
assembly (D).
10. Remove the stapler carriage motor assembly (C).
To Next Page
Loading...
