4-58 Finisher Service Manual
4024-XXX
Sensor (stapler carriage HP) removal
1. Remove the finisher front door assembly. See “Finisher front door assembly removal” on page 4-27.
2. Remove the staple cartridge.
3. Remove the rear upper cover. See “Rear upper cover removal” on page 4-24.
4. Remove the rear lower cover. See “Rear lower cover removal” on page 4-23.
5. Remove the stapler unit frame. See “Stapler unit frame removal” on page 4-54.
6. Remove the stapler unit assembly. See “Stapler unit assembly removal” on page 4-56.
7. Release the hooks securing the sensor (stapler carriage HP) (A) to the stapler carriage assembly (B).
8. Remove the sensor (stapler carriage HP) (A).
To Next Page
Loading...
